|
|
Report the following:
| • | 1. Date when specimen was cast or extracted. |
| • | 2. Concrete mixture or material reference number and all other relevant information (cement type, cure duration, w/c ratio, etc.). |
| • | 3. For each tested specimen, provide a table including complete experimental records and all dimensions measured. |
| • | 4. Plot experimental measurements against testing time (Figure 11.12). |
| • | 5. Plot the remaining water content of each tested specimen against testing time (Figure 11.12) once material porosity has been determined. Remaining water content is calculated by the following procedure: volume of specimen (cm3) = Weight in air (g) – Weight in water (g); remaining water content (%) = [(Porosity (%) x Volume (cm3)/100 – cumulative mass loss (g)]/Volume (cm3) x 100. |
Web site: http://www.simcotechnologies.com/
